Skip to Content

Changes for page LX5V-2PT2DAI

Last modified by WeconTurkey on 2024/10/16 22:58
From version 13.1
edited by Karen
on 2023/05/29 16:19
Change comment: There is no comment for this version
To version 11.1
edited by Karen
on 2023/05/29 16:18
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -120,11 +120,11 @@
120 120  1. 3-wire PT100: When using channel 1, two leads of the same color are connected to L1- and VI- respectively, and the other lead of different color is connected to L1+. Channel 2 is connected in the same way.
121 121  
122 122  |[[image:image-20221222110545-3.png]]
123 -|Cut off the power before installing, removing or wiring the BD module to avoid electric shock or product damage.
123 +|Cut off the power before installing, removing or wiring the BD board to avoid electric shock or product damage.
124 124  
125 125  **✎Note:**
126 126  
127 -*
127 +* \\
128 128  ** Do not place signal cables near high voltage power cables or in the same trunk line. Otherwise, it may be disturbed or surged. Keep a safe distance between signal cable and power cable, at least 100mm.
129 129  ** Ground the shielding of shielded wire or shielded cable. But the ground point and high voltage line cannot be the same.
130 130  ** Do not connect cables of impermissible size to avoid poor contact or product damage.
... ... @@ -165,11 +165,11 @@
165 165  
166 166  = **5. Description of PLC device** =
167 167  
168 -~1. When connected to LX3 series PLC, please refer to LX3 series BD module manual.
168 +~1. When connected to LX3 series PLC, please refer to LX3 series BD board manual.
169 169  
170 -2. When connected to LX5 series PLC, if the firmware version of PLC is lower than 2.051 (excluding 2.051), or BD module is not configured by host computer, it can be controlled by the following system devices:
170 +2. When connected to LX5 series PLC, if the firmware version of PLC is lower than 2.051 (excluding 2.051), or BD board is not configured by host computer, it can be controlled by the following system devices:
171 171  
172 -3. User can select device through I/O mapping to use the configuration function of new BD module. For details, please refer to "[[6.1 Parameter configuration>>path:#_6.1 参数配置]]".
172 +3. User can select device through I/O mapping to use the configuration function of new BD board. For details, please refer to "[[6.1 Parameter configuration>>path:#_6.1 参数配置]]".
173 173  
174 174  **Device allocation**
175 175