Skip to Content

Changes for page LX5V-2PT2DAI

Last modified by WeconTurkey on 2024/10/16 22:58
From version 3.1
edited by Jim
on 2022/12/22 11:16
Change comment: There is no comment for this version
To version 4.1
edited by Jim
on 2022/12/22 11:19
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -124,7 +124,7 @@
124 124  
125 125  **✎Note:**
126 126  
127 -*
127 +*
128 128  ** Do not place signal cables near high voltage power cables or in the same trunk line. Otherwise, it may be disturbed or surged. Keep a safe distance between signal cable and power cable, at least 100mm.
129 129  ** Ground the shielding of shielded wire or shielded cable. But the ground point and high voltage line cannot be the same.
130 130  ** Do not connect cables of impermissible size to avoid poor contact or product damage.
... ... @@ -209,8 +209,9 @@
209 209  
210 210  ③ After adding the BD board to the slot, double-click or right-click to select configuration parameters to enter LX5V-2PT2DAI-BD configuration parameters interface, as shown in the following figure. Configure related parameters on this interface.
211 211  
212 -[[image:image-20221222111514-3.png]]
212 +[[image:image-20221222111948-1.png]]
213 213  
214 +
214 214  **Note: This function is only supported in the following versions of host computer, slave computer and BD board:**
215 215  
216 216  (1) Supported host computer software versions: Wecon PLC Editor2 2.1.204 and above, as shown in the following figure:
image-20221222111948-1.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.Jim
Size
... ... @@ -1,0 +1,1 @@
1 +91.0 KB
Content