Skip to Content

Changes for page 08 Motion Control

Last modified by Iris on 2026/04/03 10:39
From version 5.2
edited by Iris
on 2025/10/22 15:12
Change comment: There is no comment for this version
To version 5.4
edited by Iris
on 2025/10/22 15:17
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -2204,6 +2204,8 @@
2204 2204  
2205 2205  
2206 2206  
2207 +
2208 +
2207 2207  == **Management functions of axis group motion control** ==
2208 2208  
2209 2209  ----
... ... @@ -5192,6 +5192,25 @@
5192 5192  |0x00600011|MC_ERROR_ID_SERVO_PARAWRITE|Write Servo parameter error
5193 5193  |0x00600012|MC_ERROR_ID_LOCAL_PULSE_HOME_TIMEOUT|Time out when origin regression
5194 5194  |0x00600013|MC_ERROR_ID_LOCAL_PULSE_HOME_NOT_TOUCH_LIMI|The execution has not encountered the limit
5197 +|0x00600014|(((
5198 +MC_ERROR_ID_LOCAL_PULSE_HOME_VELOCITY_
5199 +
5200 +OVER_LIMIT
5201 +)))|Pulse shaft HOME Velocity over limit
5202 +|0x00600015|(((
5203 +MC_ERROR_ID_LOCAL_PULSE_HOME_ACC_
5204 +
5205 +OVER_LIMIT
5206 +)))|Pulse shaft HOME Acceleration over limit
5207 +|0x00600020|(((
5208 +MC_ERROR_ID_MODE_SWITCH_NEEDPDO_
5209 +
5210 +NOTMAP
5211 +)))|(((
5212 +There is no required PDO for the mode
5213 +
5214 +corresponding to mode switching.
5215 +)))
5195 5195  |0x006000FF|MC_ERROR_ID_SERVO_LOST|Servo lost
5196 5196  |(% colspan="3" %)**Axis’s error**
5197 5197  |0x00700000|MC_ERROR_ID_AXIS_GENERAL_ERROR|Axis's general error