Crouzet
Last modified by Hunter on 2023/08/24 18:13
Crouzet
M3 (FBD)
Support Series: Crouzet Millenium 3 CD12/CB12
HMI Settings
| Item | Recommended | Note |
|---|---|---|
| Protocol | CROUZET M3 (FBD) | |
| Connection | RS232 | |
| Baud rate | 115200 | |
| Stop bits | 1 | |
| Data bits | 7 | |
| Parity | EVEN | |
| PLC Station No. | 1 | |
| HMI Station No. | 0 |
Address List
| Type | Device registers | Format | Range | Note |
|---|---|---|---|---|
| Bit | I | I DD | 1~99 | Input |
| SLIBit | SLIBit DD.dd | 1.0~24.15 | Serial Link Input | |
| SLOBit | SLOBit DD.dd | 25.0~48.15 | Serial Link Output(Read only) | |
| State | State D | 1~1 | PLC state(Read only) | |
| Word | AI | AI DD | 1~99 | Analog Input |
| SLIn | SLIn DD | 1~24 | Serial Link Input | |
| SLOut | SLOut DD | 25~48 | Serial Link Output(Read only) | |
| Time | Time D | 1~6 | Time1: Second Time2: Minute Time3: Hour Time4: Day Time5: Month Time6: Year | |
| Order | Order D | 1~1 | Running command(Write only) =2: Run mode; =1: Stop mode; |
Cable Wiring
✎Note: As the communication driver remark mentioned, this protocol requires the DB9 serial port pin 4. But pin 4 is not define, not used or not useful(e.g. the pin 4 is the B- terminal of 485_2 of ig series) for PI HMIs, so it need the user to solder a Pull-up resistor to make the pin 4 working. As for how to solder the resistor on the motherboard, please contact with Wecon technical support for the details.