Skip to Content
Last modified by Mora Zhou on 2024/08/08 14:35
From version 25.1
edited by Stone Wu
on 2022/09/26 10:18
Change comment: There is no comment for this version
To version 25.4
edited by Stone Wu
on 2022/09/26 10:28
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -1098,7 +1098,7 @@
1098 1098  
1099 1099  Specify the output pulse duty ratio in (s1). (The setting range is 0 to 1000)
1100 1100  
1101 -Specify the output pulse period in (s2). (The setting range is 1 to 32,767ms)
1101 +Specify the output pulse period in (s2). (The setting range is 1 to 32,767)
1102 1102  
1103 1103  Specify the device that outputs the pulse in (d). Only Y devices with positioning parameters can be specified.
1104 1104  
... ... @@ -1106,7 +1106,7 @@
1106 1106  
1107 1107  High level time (ms) = set cycle time (ms) x duty cycle / 1000
1108 1108  
1109 -Low level time (ms) = period (ms)-high level time (ms)
1109 +Low level time (ms) = period (ms) - high level time (ms)
1110 1110  
1111 1111  That is, the period is set to 100ms, if the duty cycle is set to 500, the output is high for 50ms and low for 50ms; if the duty cycle is set to 100, the output is high for 10ms and low for 90ms; If it is set to 900, the output will be high for 90ms and low for 10ms. The fractional part of the calculated pulse output time is output by rounding.
1112 1112  
... ... @@ -1115,13 +1115,11 @@
1115 1115  **✎Note:**
1116 1116  
1117 1117  1. Please be careful not to overlap with other control devices.
1118 -1. About pulse output
1118 +1. About pulse output: This instruction is executed in interrupt mode. When the instruction power flow is OFF, the output stops. (s1) and (s2) can be changed when the PWM instruction is executed. If it is modified to an incorrect parameter, the sending of PWM pulse will be stopped.
1119 1119  
1120 -This instruction is executed in interrupt mode. When the instruction power flow is OFF, the output stops. (s1) and (s2) can be changed when the PWM instruction is executed. If it is modified to an incorrect parameter, the sending of PWM pulse will be stopped.
1121 -
1122 1122  **Related device**
1123 1123  
1124 -• Percentage mode flag
1122 +• Permil mode flag
1125 1125  
1126 1126  (% class="table-bordered" %)
1127 1127  |=(% scope="row" %)**Output shaft**|**Y0**|**Y1**|**Y2**|**Y3**|**Y4**|**Y5**|**Y6**|**Y7**