Skip to Content

Changes for page 10 Malfunctions

Last modified by Iris on 2026/04/17 16:14
From version 2.1
edited by Iris
on 2026/04/17 14:17
Change comment: There is no comment for this version
To version 3.1
edited by Iris
on 2026/04/17 16:12
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -830,11 +830,19 @@
830 830  
831 831  |=(% style="width: 299px;" %)**Reason**|=(% style="width: 457px;" %)**Troubleshooting methods**|=(% style="width: 320px;" %)**Handling**
832 832  |(% style="width:299px" %)The electronic gear ratio setting is greater than the settable range|(% style="width:457px" %)(((
833 -Check that the ratio of function codes P00-17/P00-18, P00-19/P00-20 is in the following range.
833 +Check that the ratio of function codes P01-17/P01-18, P01-19/P00-20 is in the following range.
834 834  
835 -17bit absolute encoder upper limit value: 500.
835 +17bit absolute encoder upper limit value:
836 836  
837 -23bit absolute encoder upper limit value: 32000
837 +VD2, VD2F, 13108;
838 +
839 +VD2:1311
840 +
841 +23bit absolute encoder upper limit value:
842 +
843 +VD2, VD2F: 838861;
844 +
845 +VD2L: 83887
838 838  )))|(% rowspan="2" style="width:320px" %)After modifying the corresponding function code according to the range, set P10-03 (fault clearance) to 1.
839 839  |(% style="width:299px" %)The electronic gear ratio setting is less than the settable range|(% style="width:457px" %)(((
840 840  Check that the ratio of function codes P00-17/P00-18, P00-19/P00-20 is in the following range.