Changes for page 10 Malfunctions

Summary

• Page properties (1 modified, 0 added, 0 removed)
• Attachments (0 modified, 1 added, 0 removed)
  • ksjakfjk.png

Details

Page properties

Content

...	...	@@ -145,6 +145,10 @@
145	145
146	146	= **Overview** =
147	147
	148	+
	149	+(% style="text-align:center" %)
	150	+[[image:ksjakfjk.png]]
	151	+
148	148	The faults and warnings of Wecon VD2 series servo drives are graded according to their severity, which can be divided into four grades: Category 1, Category 2, Category 3, Category 4. Severity level: Category 1> Category 2> Category 3 > Category 4, the specific classifications are as follows:
149	149
150	150	Category 1: faults cannot be cleared;
...	...	@@ -160,6 +160,7 @@
160	160	1. Set the function code P10-03=1 (fault clearing) or use DI function 02 (02-A-CLR, fault and warning clearing) and set it to logic valid, which can stop the fault display on the panel.
161	161	1. The clearing method of category 2 and category 3 clearable faults: first turn off the servo enable signal (set S-ON to OFF), then set P10-03=1 or use DI function 02.
162	162	1. The clearing method of category 4 of clearable warnings: set P10-03=1 or use DI function 02.[[image:image-20220611130000-2.png]]
	167	+1. [[image:image-20220611130024-3.png]]
163	163
164	164	|(% style="text-align:center; vertical-align:middle" %)[[image:image-20220611125934-1.png]]
165	165	|For some faults and warnings, you must change the settings to eliminate the causes before they can be cleared, but clearing does not mean that the changes take effect. For the changes that need to be re-powered to take effect, the power must be re-powered. For the changes that need to be stopped to take effect, the servo enable must be turned off. After the change takes effect, the servo drive can operate normally.

ksjakfjk.png

Author

...	...	@@ -1,0 +1,1 @@
	1	+XWiki.admin

Size

...	...	@@ -1,0 +1,1 @@
	1	+1.8 KB

Content