Skip to Content

Changes for page 10 Malfunctions

Last modified by Theodore Xu on 2025/02/13 17:16
From version 2.4
edited by Leo Wei
on 2022/06/11 13:00
Change comment: There is no comment for this version
To version 5.1
edited by Stone Wu
on 2022/06/11 14:20
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.admin
1 +XWiki.Stone
Content
... ... @@ -145,6 +145,10 @@
145 145  
146 146  = **Overview** =
147 147  
148 +
149 +(% style="text-align:center" %)
150 +[[image:ksjakfjk.png]]
151 +
148 148  The faults and warnings of Wecon VD2 series servo drives are graded according to their severity, which can be divided into four grades: Category 1, Category 2, Category 3, Category 4. Severity level: Category 1> Category 2> Category 3 > Category 4, the specific classifications are as follows:
149 149  
150 150  Category 1: faults cannot be cleared;
... ... @@ -159,10 +159,12 @@
159 159  
160 160  1. Set the function code P10-03=1 (fault clearing) or use DI function 02 (02-A-CLR, fault and warning clearing) and set it to logic valid, which can stop the fault display on the panel.
161 161  1. The clearing method of category 2 and category 3 clearable faults: first turn off the servo enable signal (set S-ON to OFF), then set P10-03=1 or use DI function 02.
162 -1. The clearing method of category 4 of clearable warnings: set P10-03=1 or use DI function 02.[[image:image-20220611130000-2.png]]
163 -1. [[image:image-20220611130024-3.png]]
166 +1. The clearing method of category 4 of clearable warnings: set P10-03=1 or use DI function 02.
164 164  
165 -|(% style="text-align:center; vertical-align:middle" %)[[image:image-20220611125934-1.png]]
168 +|(% style="text-align:center; vertical-align:middle" %)(((
169 +(% style="text-align:center" %)
170 +[[image:ksjakfjk.png]]
171 +)))
166 166  |For some faults and warnings, you must change the settings to eliminate the causes before they can be cleared, but clearing does not mean that the changes take effect. For the changes that need to be re-powered to take effect, the power must be re-powered. For the changes that need to be stopped to take effect, the servo enable must be turned off. After the change takes effect, the servo drive can operate normally.
167 167  
168 168  Associated function codes
ksjakfjk.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.admin
Size
... ... @@ -1,0 +1,1 @@
1 +1.8 KB
Content