Skip to Content

Changes for page 10 Malfunctions

Last modified by Theodore Xu on 2025/02/13 17:16
From version 2.6
edited by Leo Wei
on 2022/06/11 13:03
Change comment: There is no comment for this version
To version 7.1
edited by Joey
on 2022/06/11 15:39
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.admin
1 +XWiki.Joey
Content
... ... @@ -145,10 +145,6 @@
145 145  
146 146  = **Overview** =
147 147  
148 -
149 -(% style="text-align:center" %)
150 -[[image:ksjakfjk.png]]
151 -
152 152  The faults and warnings of Wecon VD2 series servo drives are graded according to their severity, which can be divided into four grades: Category 1, Category 2, Category 3, Category 4. Severity level: Category 1> Category 2> Category 3 > Category 4, the specific classifications are as follows:
153 153  
154 154  Category 1: faults cannot be cleared;
... ... @@ -163,10 +163,12 @@
163 163  
164 164  1. Set the function code P10-03=1 (fault clearing) or use DI function 02 (02-A-CLR, fault and warning clearing) and set it to logic valid, which can stop the fault display on the panel.
165 165  1. The clearing method of category 2 and category 3 clearable faults: first turn off the servo enable signal (set S-ON to OFF), then set P10-03=1 or use DI function 02.
166 -1. The clearing method of category 4 of clearable warnings: set P10-03=1 or use DI function 02.[[image:image-20220611130000-2.png]]
167 -1. [[image:image-20220611130024-3.png]]
162 +1. The clearing method of category 4 of clearable warnings: set P10-03=1 or use DI function 02.
168 168  
169 -|(% style="text-align:center; vertical-align:middle" %)[[image:image-20220611125934-1.png]]
164 +|(% style="text-align:center; vertical-align:middle" %)(((
165 +(% style="text-align:center" %)
166 +[[image:ksjakfjk.png]]
167 +)))
170 170  |For some faults and warnings, you must change the settings to eliminate the causes before they can be cleared, but clearing does not mean that the changes take effect. For the changes that need to be re-powered to take effect, the power must be re-powered. For the changes that need to be stopped to take effect, the servo enable must be turned off. After the change takes effect, the servo drive can operate normally.
171 171  
172 172  Associated function codes
ksjakfjk.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.admin
Size
... ... @@ -1,0 +1,1 @@
1 +1.8 KB
Content