Skip to Content

Changes for page 10 Malfunctions

Last modified by Theodore Xu on 2025/02/13 17:16
From version 78.1
edited by Stone Wu
on 2022/07/09 17:32
Change comment: Deleted image "image-20220709163239-7.png"
To version 81.1
edited by Stone Wu
on 2022/08/24 11:39
Change comment: There is no comment for this version

Summary

Details

Page properties
Parent
... ... @@ -1,1 +1,1 @@
1 -Servo.1 User Manual.02 VD2 SA Series.WebHome
1 +Servo.Manual.02 VD2 SA Series.WebHome
Content
... ... @@ -297,7 +297,7 @@
297 297  check abnormal and frequency is too high
298 298  )))|(% style="width:96px" %)Yes|(% style="width:115px" %)Continue to run
299 299  
300 -== **Troubleshooting** ==
300 += **Troubleshooting** =
301 301  
302 302  **Er.01 Parameter destruction**
303 303  
... ... @@ -304,7 +304,7 @@
304 304  Fault
305 305  
306 306  |=(% style="width: 460px;" %)**Servo drive panel display**|=(% style="width: 615px;" %)**Fault name**
307 -|(% style="width:460px" %)[[image:image-20220709165342-1.png]]|(% style="width:615px" %)Parameter destruction
307 +|(% style="width:460px" %)[[image:image-20220709173736-1.png]]|(% style="width:615px" %)Parameter destruction
308 308  
309 309  Troubleshooting
310 310  
... ... @@ -956,7 +956,6 @@
956 956  Priority is given to the use of motor power lines and encoder cables as standard by manufacturers
957 957  )))
958 958  |(% style="width:233px" %)The load is too large|(% style="width:454px" %)Check overload characteristics of motor or servo drive|Reduce the load. Contact technical to obtain the appropriate capacity drive and motor model.
959 -|(% style="width:233px" %)Frequent acceleration and deceleration|(% style="width:454px" %)Check whether the acceleration and deceleration motion is frequent or the acceleration and deceleration time is too small|Appropriately extend the acceleration and deceleration time
960 960  |(% style="width:233px" %)Motor model and servo driver do not match|(% style="width:454px" %)Perform inertia identification and check the inertia ratio.|Contact technician to obtain the matching motor model.
961 961  |(% style="width:233px" %)Motor model and servo driver do not match|(% style="width:454px" %)Check the monitoring quantity U0-53 (motor model code).|Contact technician to obtain the matching motor model.
962 962  |(% rowspan="2" style="width:233px" %)Unreasonable parameters|(% style="width:454px" %)Use Wecon SCTools to obtain the actual torque waveform and observe whether overshoot is obvious|Set the appropriate loop gain parameters
image-20220709173736-1.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.Stone
Size
... ... @@ -1,0 +1,1 @@
1 +33.4 KB
Content