Skip to Content
Last modified by nozzin on 2024/02/26 09:16
From version 1.5
edited by Mora Zhou
on 2024/02/23 11:48
Change comment: There is no comment for this version
To version 1.6
edited by Mora Zhou
on 2024/02/23 11:49
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -133,28 +133,36 @@
133 133  
134 134  Right click “Device” and add device
135 135  
136 +(% style="text-align:center" %)
136 136  [[image:1708659738998-621.png]]
137 137  
138 138  Add “EtherCAT Master SoftMotion”
139 139  
141 +(% style="text-align:center" %)
140 140  [[image:1708659810951-477.png]]
141 141  
142 142  Right click “EtherCAT_Master_SoftMotion” and add device, select “Wecon VD3E EtherCAT Servo_v1.10” (Servo xml file should be same with servo firmware, you can check servo firmware in U2-04 through servo panel)
143 143  
146 +(% style="text-align:center" %)
144 144  [[image:1708659837241-566.png]]
145 145  
149 +
150 +(% style="text-align:center" %)
146 146  [[image:1708659844978-946.png]]
147 147  
148 148  Add 3 motion axis
149 149  
155 +(% style="text-align:center" %)
150 150  [[image:1708659868961-294.png]]
151 151  
152 152  Set the correct resolution based on the motor encoder
153 153  
160 +(% style="text-align:center" %)
154 154  [[image:1708659882131-694.png]]
155 155  
156 156  Double click “EtherCAT_Master_SoftMotion” and select network name “eth1” in “General”
157 157  
165 +(% style="text-align:center" %)
158 158  [[image:1708659902425-597.png]]
159 159  
160 160  Bind axis to robot.