Skip to Content
Last modified by Theodore Xu on 2024/04/10 09:11
From version 33.1
edited by Theodore Xu
on 2024/01/16 17:12
Change comment: There is no comment for this version
To version 31.1
edited by Leo Wei
on 2023/12/29 09:51
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.AiXia
1 +XWiki.admin
Content
... ... @@ -25,7 +25,7 @@
25 25  
26 26  **RS485 Connection Topology**
27 27  
28 -RS485 bus connection topology is shown in the following figure. 485 bus is recommended to use shielded twisted pair (STP), 485+, 485-: **Adopt twisted pair to connect**; Only 120 Ω terminal matching resistors are connected at both ends of the bus to prevent signal reflection; All node 485 signal grounds are connected together; Connect 128 nodes at most, and the distance between branches of each node should be less than 3m.
28 +RS485 bus connection topology is shown in the following figure. 485 bus is recommended to use shielded twisted pair (STP), 485+, 485-: Adopt twisted pair to connect; Only 120 Ω terminal matching resistors are connected at both ends of the bus to prevent signal reflection; All node 485 signal grounds are connected together; Connect 128 nodes at most, and the distance between branches of each node should be less than 3m.
29 29  
30 30  **Multi-node connection mode**
31 31  
... ... @@ -51,11 +51,6 @@
51 51  
52 52  The maximum number of nodes and transmission distance supported by our standard RS485 circuit at different rates are shown in the following table.
53 53  
54 -The communication distance between the inverter and other devices should not exceed **200 meters**, if it exceeds two hundred meters it may cause unstable communication. If the communication distance **exceeds 200 meters**, the following measures need to be included:
55 -
56 -* Communication cable：Adopt twisted pair to connect
57 -* anti-interference magnetic ring
58 -
59 59  |Transmission distance (m)|Rate (kbps)|Number of nodes|Wire diameter
60 60  |100|115.2|128|AWG26
61 61  |1000|19.2|128|AWG26