Skip to Content

Changes for page 06 Data Tool

Last modified by Jett on 2025/02/18 16:43
From version 28.1
edited by Karen
on 2023/06/07 09:29
Change comment: There is no comment for this version
To version 31.1
edited by Jim
on 2023/08/11 09:32
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.Karen
1 +XWiki.Jim
Content
... ... @@ -19,23 +19,21 @@
19 19  
20 20  **Upload to Cloud: **The data upload by "bit alarm" is stored in the Cloud and it is alarm data. (Only ig series and 8000/9000 series with -R after system upgrade are supported)
21 21  
22 +(% class="box infomessage" %)
23 +(((
22 22  **✎Note:**
23 23  
24 24  * After enable the Cloud and check the box of Upload to Cloud, the communication port settings of the address in the imported Bit Alarm record configuration must be the same as the communication port settings of the current project, otherwise it cannot be used normally.
25 25  * The number of Alarm records upload to Cloud shall not exceed the limit value, or the sum of the imported alarm records and the number of existing alarm records shall not exceed the limit value. the specific limitation as following table:
26 26  
27 -(% style="margin-left:auto; margin-right:auto; width:358px" %)
29 +(% class="table-bordered" style="margin-left:auto; margin-right:auto; width:358px" %)
28 28  |=(% style="width: 79px;" %)Series|=(% style="width: 276px;" %)Number of Alarm upload to Cloud
29 29  |(% style="width:79px" %)8000-R|(% style="text-align:center; width:276px" %)200
30 30  |(% style="width:79px" %)9000-R|(% style="text-align:center; width:276px" %)200
31 31  |(% style="width:79px" %)3000ig|(% style="text-align:center; width:276px" %)20
32 32  |(% style="width:79px" %)8000ig|(% style="text-align:center; width:276px" %)200
35 +)))
33 33  
34 -(% class="table-bordered" style="margin-left:auto; margin-right:auto" %)
35 -|= |=
36 -| |
37 -| |
38 -
39 39  **Alarm Condition:** It sets alarm trigger condition, there are two types: alarm when ON and alarm when OFF.
40 40  
41 41  **Alert: **It is used to mark whether the alarm has occurred. if an alarm occurs, the address of "control bit" will be written to 1. If "clear alert when alarm OFF" is checked, the address of "control bit" will be written to 0.