Skip to Content

Changes for page 06 Operation

Last modified by Iris on 2025/07/23 15:49
From version 100.1
edited by Mora Zhou
on 2025/04/29 11:01
Change comment: There is no comment for this version
To version 98.3
edited by Mora Zhou
on 2025/04/29 11:00
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -2880,7 +2880,7 @@
2880 2880  )))
2881 2881  
2882 2882  
2883 -= Homing mode =
2883 +== Homing mode ==
2884 2884  
2885 2885  The homing mode is used to find the mechanical origin and locate the positional relationship between the mechanical origin and the mechanical zero.
2886 2886  
... ... @@ -2901,8 +2901,9 @@
2901 2901  
2902 2902  
2903 2903  
2904 -=== Homing mode related function codes ===
2905 2905  
2905 +6.8. 2 Homing mode related function codes
2906 +
2906 2906  |Function code|Name|(((
2907 2907  Setting
2908 2908  
... ... @@ -2928,6 +2928,7 @@
2928 2928  2: DI enable
2929 2929  )))|-
2930 2930  
2932 +
2931 2931  |Function code|Name|(((
2932 2932  Setting
2933 2933  
... ... @@ -3058,8 +3058,12 @@
3058 3058  When P10-6 is set to 1, the value of U0-56 is updated to P10-8.
3059 3059  )))|-
3060 3060  
3061 -== Introduction to homing mode ==
3062 3062  
3064 +
3065 +
3066 +
3067 +Introduction to homing mode
3068 +
3063 3063  In the following figure, "H" represents P01-41 (high-speed search deceleration point signal speed), and "L" represents P01-42 (low-speed search homing signal speed).
3064 3064  
3065 3065