Skip to Content

Changes for page 06 Operation

Last modified by Iris on 2025/07/23 15:49
From version 104.1
edited by xingzhi lin
on 2025/05/26 14:10
Change comment: There is no comment for this version
To version 105.2
edited by Iris
on 2025/07/21 15:56
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.lxz
1 +XWiki.Iris
Content
... ... @@ -83,14 +83,14 @@
83 83  0
84 84  )))|(((
85 85  0 to 1
86 -)))|Forward: facing the motor axis.
87 -0: Standard setting (CW is forward);
88 -1: Reverse mode (CCW is forward);
89 -2: Reverse mode (CCW is forward), set P1-12,
90 -P1-17 to limit the CCW direction speed; set
91 -P1-13, P1-18 to limit the CW direction speed.
92 -**Note:VD2L driver P0-04 setting range: 0~~1, not support P00-4=2!**|-
86 +)))|(((
87 +Forward rotation: Face the motor shaft to watch
93 93  
89 +0: standard setting (CW is forward rotation)
90 +
91 +1: reverse mode (CCW is forward rotation)
92 +)))|-
93 +
94 94  Table 6-3 Rotation direction parameters** **
95 95  
96 96  == **Braking resistor** ==
... ... @@ -3761,7 +3761,7 @@
3761 3761  ① The deceleration point signal is invalid when starting homing, the reverse limit switch is encountered
3762 3762  
3763 3763  (% style="text-align:center" %)
3764 -[[image:1748227761818-990.jpg||height="394" width="600"]]
3764 +[[image:1751361620036-469.png||height="389" width="600"]]
3765 3765  
3766 3766  When it starts to homing, HW=0, it starts to homing at a reverse high speed. When encountering a limit switch, it automatically reverses and runs at a forward high speed. When encountering a rising edge of HW, it decelerates and runs at a forward low speed. When encountering a falling edge of HW, it reverses and runs at a reverse low speed. When encountering a rising edge of HW, it stops.
3767 3767  
1751361620036-469.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.lxz
Size
... ... @@ -1,0 +1,1 @@
1 +56.0 KB
Content