Skip to Content

Changes for page 06 Operation

Last modified by Iris on 2025/07/23 15:49
From version 98.2
edited by Mora Zhou
on 2025/04/29 10:58
Change comment: There is no comment for this version
To version 98.3
edited by Mora Zhou
on 2025/04/29 11:00
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -2880,9 +2880,8 @@
2880 2880  )))
2881 2881  
2882 2882  
2883 +== Homing mode ==
2883 2883  
2884 -6.8 Homing Model (HM)
2885 -
2886 2886  The homing mode is used to find the mechanical origin and locate the positional relationship between the mechanical origin and the mechanical zero.
2887 2887  
2888 2888  Mechanical homing: A mechanically fixed position may correspond to a certain defined homing switch, or may correspond to the motor Z signal.
... ... @@ -2896,7 +2896,7 @@
2896 2896  When P10-08=0, the mechanical homing coincides with the mechanical zero.
2897 2897  
2898 2898  
2899 -6.8.1 Control block diagram
2898 +=== Control block diagram ===
2900 2900  
2901 2901  [[image:file:///C:\Users\Administrator\AppData\Local\Temp\ksohtml22584\wps1.png]]Figure 6-53 Homing mode control block diagram
2902 2902  
... ... @@ -3065,10 +3065,8 @@
3065 3065  
3066 3066  
3067 3067  
3067 +Introduction to homing mode
3068 3068  
3069 -
3070 -6.8.2 Introduction to homing method
3071 -
3072 3072  In the following figure, "H" represents P01-41 (high-speed search deceleration point signal speed), and "L" represents P01-42 (low-speed search homing signal speed).
3073 3073  
3074 3074