Skip to Content

Changes for page 06 Operation

Last modified by Iris on 2025/07/23 15:49
From version 98.3
edited by Mora Zhou
on 2025/04/29 11:00
Change comment: There is no comment for this version
To version 100.1
edited by Mora Zhou
on 2025/04/29 11:01
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -2880,7 +2880,7 @@
2880 2880  )))
2881 2881  
2882 2882  
2883 -== Homing mode ==
2883 += Homing mode =
2884 2884  
2885 2885  The homing mode is used to find the mechanical origin and locate the positional relationship between the mechanical origin and the mechanical zero.
2886 2886  
... ... @@ -2901,9 +2901,8 @@
2901 2901  
2902 2902  
2903 2903  
2904 +=== Homing mode related function codes ===
2904 2904  
2905 -6.8. 2 Homing mode related function codes
2906 -
2907 2907  |Function code|Name|(((
2908 2908  Setting
2909 2909  
... ... @@ -2929,7 +2929,6 @@
2929 2929  2: DI enable
2930 2930  )))|-
2931 2931  
2932 -
2933 2933  |Function code|Name|(((
2934 2934  Setting
2935 2935  
... ... @@ -3060,12 +3060,8 @@
3060 3060  When P10-6 is set to 1, the value of U0-56 is updated to P10-8.
3061 3061  )))|-
3062 3062  
3061 +== Introduction to homing mode ==
3063 3063  
3064 -
3065 -
3066 -
3067 -Introduction to homing mode
3068 -
3069 3069  In the following figure, "H" represents P01-41 (high-speed search deceleration point signal speed), and "L" represents P01-42 (low-speed search homing signal speed).
3070 3070  
3071 3071